Purchase cheap costume hat and remove 'embellishment' begin to unweave rear portion.
Phase 2
Re-weave rear portion of hat to shape around read of head/back of neck. Attempt to finish much more nicely than original. I tried being lazy and just re-weaving dry but I was getting too much breakage at the edge so I wet the straw. It was so thin that I just had to run the faucet on it for a bit. I think it's easy to tell which strand was done by each method. :) I also wove the extra bits into the existing crown to cover the four eyelets which had been part of the original design.
Phase 3
Paint the hat.
Phase 4
Line hat and bind outer edge. I lined the hat with leftover scrap silk from the bustle dress I hope the wear the hat with, then realized that committing myself to silk meant that I couldn't edge or trim the bonnet with the polyester ribbons I had been planning on incorporating. They just look too cheap and thick and clunky in comparison! I'm going to have to find something appropriate to introduce on the hat so it doesn't look to matchy-matchy but a good start is to use my plaid fabric in a variety of ways to play up the inherent differences. Thus, the inside of the brim is a band of black surrounding a band or gray, the interior of the hat is a band of stripes surrounding the original plaid, and the edging is a band of alternating black and black and brown stripes. Whew!
Phase 5
Touch up paint on the hat!
Phase 6
Trim. And trim. And trim some more!
When I cut up my scrap fabric to get material for the edge binding I also cut out the straw-and-black striped section I planned to use for trim. I used my new scalloped pinking shears for the very first time and...wow! I have hoards of tiny black cotton lace that has yet to be used on the dress which I think I'll use to trim the edges and give the bows more body. You can't really go wrong with adding more trim to an 1880's hat!
Hmmm, however, you can go wrong by adding too little!
It just looks a little skimpy on the sides...
No comments:
Post a Comment