IRCC3 - Accessory One: Hairpins

My embroidering continues but I was feeling a need to have a layer completed during the first month so I woke up today and took out my supplies for the smallest and most useful of my planned projects, hairpins!

Step-By-Step:

Unwind 16 gauge brass wire
Cut into sections measured against a handy paperback novel
Bend in half
Twist into tight loop on end
Bend each leg of hairpin back and forth to make a wavy line (which is modern but will actually HOLD my hair)
Separate decorative acorn brass beads from original chain
Snip off loop at tip of acorn
Slide acorn ornament onto loop at end of bent-wire hairpin and tighten
File cut edges as needed
Hammer legs of pin slightly flat to decrease softness of metal

I'm going to have 15 of these babies!